Stratasys Objet500 User Manual page 173

Objet500 User Guide
12. Click Next to display the next head alignment screen, and again select the
13. Continue as follows:
14. In the following screen, you can choose to either repeat the head
DOC-07027 Rev. E
number representing the most closely aligned vertical lines on the
transparency for that print head.
When you have finished aligning all of the heads, the following screen is
displayed.
Figure 6-52 Parameter update confirmation
❒ To make the alignment changes in the printer, make sure that Update
system with new parameters is selected, and click Next.
❒ To recheck the alignment test results before making the alignment
changes in the printer, click Previous.
❒ If you do not want to make alignment changes in the printer at this
time, select Keep previous parameters and click Next.
alignment procedure or close the wizard.
❒ If the most closely aligned vertical lines for a print head were at either
extreme, choose Yes to run the Head Alignment wizard again, then
click Next.
The transparency test will show if the heads are now properly aligned,
and—if not—the wizard will allow you to "fine tune" the alignment.
❒ If the vertical lines for the print heads were not aligned at either
extreme, choose No to close the wizard, then click Next.
Figure 6-53 Repeat head alignment option
6 Operating and Maintaining the Objet500 3D Printer
6-42