Objet500 User Guide
Installing the New Head
15. Inspect the replacement head, and make sure that the O-ring seals are in
16. Gently insert the replacement head into the vacant slot in the print block,
17. Push the head up until you hear it click into place, in both front and rear
18. Lower the door of the print head compartment, and tighten the screws to
19. Tighten the upper and lower screws that secure the print head in the print
DOC-07027 Rev. E
place (see Figure 6-76 on the previous page).
and push the print-head driver card into its socket.
Note: Make sure to insert the head with the driver card facing its socket, in the
rear of the print block.
Figure 6-78 Inserting the print-head driver card into its socket
holders.
Figure 6-79 Pushing the head into place in the print block
lock it in place.
block (see Figure 6-72 on page 6-54).
Note: Hand-tighten these screws. Do not use a screwdriver.
6 Operating and Maintaining the Objet500 3D Printer
6-57