Objet500 User Guide
DOC-07027 Rev. E
The wizard operates the UV lamps and checks if their power is within the
acceptable range for each printing mode.
Note: The mode currently being checked appears in the lower-left corner of
the printer interface.
Figure 6-115 Status screen during UV lamp check
After replacing a UV lamp, it is recommended that you calibrate its power
for the various printing modes. The next screen allows you to continue to
the UV Calibration wizard "Testing and Calibrating the UV Lamps" on
page 1).
Figure 6-116 Wizard continuation screen
6 Operating and Maintaining the Objet500 3D Printer
6-75