Stratasys Objet500 User Manual page 32

Objet500 User Guide
7. In the Select Installation Folder screen, verify the destination folder and
It is recommended that you do not change the default destination folder.
Click Disk Space to check the space in the destination folder.
8. In the Confirm Installation screen, click Next to begin installation.
9. In the Select Printer Type screen, select the 3D printer used for producing
DOC-07027 Rev. E
click Next.
Figure 4-4 Objet Studio installation-folder selection
models and click Next.
Figure 4-5 Printer selection
4 Installing Objet Studio
4-4