Objet500 User Guide
9. Clean the orifice plates, with a back-and-forth motion (see Figure 6-26).
10. Clean the entire roller surface, by rotating it as you clean.
Use this opportunity to clean the glass lens on the UV lamps.
11. W hen you have finished cleaning, select the confirmation check box in
12. Remove the cleaning materials from the printer and close the cover.
13. Select the confirmation check boxes in the wizard screen and click Next.
14. Click Done to close the wizard.
DOC-07027 Rev. E
Use the mirror to make sure that you have removed all of the residue
material.
Figure 6-26 C leaning the heads
the wizard screen (see Figure 6-25) and click Next.
The head-purge cycle begins. When this is complete, the final wizard
screen appears.
Figure 6-27 Head-cleaning wizard—final screen
6 Operating and Maintaining the Objet500 3D Printer
6-28