Objet500 User Guide
4. Make sure that the build tray is empty, and close the printer cover.
5. When the following screen appears, open the cover.
6. Put on the cleaning gloves.
7. Using a generous amount of alcohol on the cleaning cloth, remove any
DOC-07027 Rev. E
Confirm this in the wizard screen and click Next.
Figure 6-29 Wiper Cleaning —step 4
Figure 6-30 W iper Cleaning wizard during steps 6–10
material remaining on the wiper and the surrounding area.
6 Operating and Maintaining the Objet500 3D Printer
6-30