Objet500 User Guide
Installation Problems
If the printer detects that there is a problem after you install print heads,
relevant warning screens appear.
• If the printer software does not detect the replaced head, the following
• If the replacement head was not factory-calibrated, the following warning
DOC-07027 Rev. E
warning screen appears.
Figure 6-85 Incorrect-installation screen
If this happens:
a. Open the print head compartment (see Figure 6-74 on page 6-55).
b. Re-insert the print-head driver card into its socket (see Figure 6-78 on
page 6-57).
c. In the wizard screen, select the check box to confirm that you have
re-inserted the card, and click Next.
screen appears.
Figure 6-86 Invalid-data warning screen
If this happens:
a. Remove the head and replace it with another one (starting with step 10
on page 6-54).
b. In the wizard screen, select the check box to confirm that you have
installed another print head, and click Next.
c. Contact your authorized Customer Support center about the
unformatted head.
6 Operating and Maintaining the Objet500 3D Printer
6-60