Table of Contents
Advertisement
Off-line Mode
DOC-13025 Rev. A
You can use Objet Studio to prepare trays for printing in off‐line mode, on
a remote computer or when the printer connection is not available. You also
use off‐line mode to prepare trays for printing with other printers. In this
case, if Objet Studio is currently connected to a printer, you must change to
off‐line mode by removing this connection.
To disconnect Objet Studio from the printer:
1. On the Job Manager ribbon, in the 3D Printer group, click
2. In the Set Printer dialog box, click
Figure 5-106: Disconnecting Objet Studio from a printer (A)
3. In the Printer Connection dialog box, delete the computer name/IP
address.
Figure 5-107: Disconnecting Objet Studio from a printer (B)
4. Click
.
OK
"Unknown" appears in the printer‐name field.
5. Click
.
OK
Connex500/350 User Guide
(see figure 5‐104).
Connect
.
5–73
Advertisement
Table of Contents
