Hollow"- Filling Models With Support Material - Stratasys Objet500 User Manual

Objet500 User Guide
"Hollow"—
Many objects placed on the tray from stl files are "solid." This means that,
Filling Models
when printed, the model will be completely filled with model material. Often,
with Support
especially with large objects, this is unnecessary. Instead, the model can be
Material
filled with support material, which is less costly. It is also advisable to fill
models with support material when preparing them for investment casting,
since this material burns off more quickly during the process of making the
cast.
Objet Studio enables you to print objects on the tray with an outer shell of
model material and a center filled with support material. When using this
feature, called "Hollow," the thickness of the shell should be no less than 0.5
millimeters.
To use the Hollow feature:
1. Select a model on the tray.
2. Select Hollow.
3. Set the shell thickness, in millimeters.
4. Click Apply.
To inspect, change or cancel the Hollow setting:
1. Select a model on the tray.
2. Access the Advanced Properties dialog box, as above.
3. If you change or cancel the Hollow setting, click Apply.
DOC-07027 Rev. E
or—
❒ On the Model Toolbar, click
or—
❒ From the right-click context menu, select Advanced Properties.
The Advanced Properties dialog box opens.
Figure 5-79 Advanced Properties dialog box
Note: There is no change in the display of objects in Objet Studio when
Hollow is selected.
.
5 Using Objet Studio
5-64