Digi Connect Sensor+ User Manual page 52

Configure Digi Connect Sensor+ device settings
11. In the DataPoint field, enter the datastream path to which you want to scope.
To monitor all of the devices that have a battery, enter: */ts1/bat
n
To monitor one specific device, enter the full stream name, which is the device ID
n
appended by /ts1/bat: 00010000-00000000-xxxxxxxx-xxxxxxxx/ts1/bat
12. Click Create. The alarm is added to the list of alarms on the Alarms page.
13. When the alarm is fired, the alarm status is updated to Fired on the Device Management >
Alarms page. Remote Manager displays the number of fired alarms in red next to the Alarms
tab on the Device Management page.
14. You can also create an alarm notification that sends an email to a list of email addresses when
an alarm fires or is reset. See
Create an alarm notification
You can create an alarm notification that sends an email to a specified email address when an alarm
fires or is reset.
Digi Connect Sensor+ User Guide
Configure battery life percentage alarms
Create an alarm notification.
52