Step 2: Activate The Sim Card; Step 3: Assemble Digi Connect Sensor - Digi Connect Sensor+ User Manual

Get started
Step 2: Activate the SIM card
Digi Connect Sensor+ has a SIM card inserted in the device by default. To use a cellular connection, you
must activate the inserted SIM card. You can skip this step if you have a pre-activated SIM card.
1. Note the Digi Connect Sensor+ IMEI number. The IMEI number is on the label on the device and
on the box the device was shipped in.
2. Activate the SIM card.
a. Navigate to
b. Email the list of Connect Sensor IMEI numbers to
NEXT STEP: After reviewing components, proceed to

Step 3: Assemble Digi Connect Sensor+

This section describes how to assemble Digi Connect Sensor+. Be sure to complete these steps before
wiring sensors to the I/O interface.
CAUTION! This product contains a lithium metal battery. Prior to installation, the
battery should be inspected for any signs of damage. If the battery appears to be
damaged or is dropped during the installation, do not use the battery and be sure to
dispose of it properly. See
Make sure you have the following equipment available:
Activated SIM card: See
n
Battery
n
Cellular antenna
n
Note You must use a passive (non-amplified) antenna with Digi Connect Sensor+.
Follow these steps to assemble Digi Connect Sensor+:
1. Open the Digi Connect Sensor+ enclosure.
2. Connect the cellular antenna.
3. Insert and connect the battery.
4. Close the cover on the device. The cover snaps into place.
5. Optional: Install the magnet mount to the bottom of Digi Connect Sensor+ if you have
purchased this accessory. See
Digi Connect Sensor+ User Guide
store.digi.com
activate the SIM(s).
Battery inspection
Activate the SIM card
CAUTION! If you are using a SIM card from your own cellular provider, do not pull
the SIM card tray up from the left side or use a tool to open the tray. These
actions may damage the SIM detect switch, which is beneath the left side of the
tray.
Install the magnet
for e-commerce-based ordering of data plans.
Data.plan.quotedesk@digi.com
Step 3: Assemble Digi Connect
for more information.
mount.
Step 2: Activate the SIM card
to
Sensor+.
11