Digi Connect Sensor+ User Manual page 123

Safety information
WARNING! Digi Connect Sensor+ is suitable for use in ATEX Zone 2, Group IIC hazardous
locations or non-hazardous locations only.
WARNING! The Digi Connect Sensor+ unit should not be installed in locations with either
pressurized or flammable materials. The battery should be replaced in unclassified areas
only.
WARNING! Install Digi Connect Sensor+ in an area that does not have more than
pollution degree 2 as defined in EN/ IEC 60664-1.
WARNING! To avoid potentially dangerous electrostatic discharges, control all likely
ignition sources, minimize the harmful effects of any accidental fire or explosion by using
explosion relief and suppression systems. All zoned areas containing potentially
explosive atmospheres should be clearly marked using ATEX Ex hazardous area warning
signs.
WARNING! Potential electrostatic charging hazard. To avoid building up an electrostatic
charge when cleaning the enclosure of this device, you must use a damp cloth moistened
only with water. Do not use flammable cleaning agents.
Digi Connect Sensor+ User Guide
Safety notices
123