Step 5: Check The Cellular Connection - Digi Connect Sensor+ User Manual

Get started
7. If required, set a user name, password, and PIN for the SIM card. At the command prompt, type
the following and press Enter after each command:
set usr=<username>
o
Where username is the name of your cellular account.
set pwd=<password>
o
Where password is the password for your cellular account.
set pin=<pin>
o
Where pin is the PIN for your SIM card.
For details about these commands, see
8. Type activate at the command prompt and press Enter to immediately make the change.
Digi Connect Sensor+ goes to sleep and immediately wakes up to report the change to Remote
Manager. After the change completes, it goes to sleep again.
9. (Optional) Verify the new settings:
a. Press the Wake button.
b. At the command prompt type set commandname where commandname is one of
NEXT STEP: After reviewing components, proceed to

Step 5: Check the cellular connection

Make sure the cellular network provides an adequate signal where you install Digi Connect Sensor+ to
maintain a consistent cellular connection.
Note Proper network coverage helps reduce power consumption, leading to improved battery life.
To check the cellular network connection at the install location:
1. Wake Digi Connect Sensor+:
If the enclosure is open, press the Wake button.
n
If the enclosure is closed, swipe the magnet across the magnet icon on the outside of
n
the device.
2. The LED indicators light up in a
3. If Digi Connect Sensor+ does not connect to the cellular network, see
the cellular
Digi Connect Sensor+ User Guide
the settings you updated, such as apn.
predetermined sequence
network.
Step 5: Check the cellular connection
CLI commands.
Step 5: Check the cellular
when you manually wake the device.
connection.
Device not connected to
14