Digi Connect Sensor+ User Manual page 100

Option CLI command Description
Enables or disables alarm reports for the
Alarms aem
analog input sources. When enabled,
sends an alarm report in one of the
following conditions:
Specifies the input value that generates a
High threshold alh
high alarm report when the high alarm is
enabled.
Specifies the input value that generates a
Low threshold all
low alarm report when the low alarm is
enabled.
Specifies the input value that generates a
Delta low adl
delta low alarm report when the delta
threshold
low alarm is enabled.
Specifies the input value that generates a
Delta high adh
delta high alarm report when the delta
threshold
high alarm is enabled.
High alarm
n
Low alarm
n
Delta high alarm
n
Delta low alarm
n
Value options
hi
n
lo
n
dh
n
dl
n
Enable multiple alarms using a
n
comma separated command
without spaces
(such as set ain1
aem=hi,lo,dh,dl)
Current loop: 4.0 - 22 (mA)
n
Voltage: 0.0 - 10.5 (volts)
n
Current loop: 4.0 - 22 (mA)
n
Voltage: 0.0 - 10.5 (volts)
n
Current loop: 4.0 - 22 (mA)
n
Voltage: 0.0 - 10.5 (volts)
n
Current loop: 4.0 - 22 (mA)
n
Voltage: 0.0 - 10.5 (volts)
n
Default
Empty (all alarms disabled)
Current loop: 20.0
n
Voltage: 10.0
n
Current loop: 4.0
n
Voltage: 0.0
n
Current loop: 16.0
n
Voltage: 10.0
n
Current loop: 16.0
n
Voltage: 10.0
n