Warnings: Explosion Hazards - Digi Connect Sensor+ User Manual

Safety information

Warnings: Explosion hazards

Review the following explosion hazard warnings for the Digi Connect Sensor+ device.
Note The Digi Connect Sensor+ device contains internal batteries.
WARNING! Digi Connect Sensor+ is suitable for use in UL/cUL Class I, Division 2, Groups
A, B, C, and D hazardous locations or non-hazardous locations only. Substitution of any
component may impair suitability for Class I, Division 2.
WARNING - EXPLOSION HAZARD: BATTERIES MUST ONLY BE CHANGED IN AN AREA
FREE OF ignitable CONCENTRATIONS.
WARNING - EXPLOSION HAZARD: DO NOT DISCONNECT WHILE THE CIRCUIT IS LIVE OR
UNLESS THE AREA IS FREE OF ignitable CONCENTRATIONS.
WARNING! Electrostatic discharge (ESD) can damage equipment and impair electrical
circuitry. ESD damage occurs when electronic components are improperly handled and
can result in complete or intermittent failures.
WARNING! When the Connect Sensor is installed in C1D2 environments, do not open the
Connect Sensor enclosure or disconnect the battery or any other connections to the
Connect Sensor until the environment around the Connect Sensor is vented or known to
be free of any flammable gas concentrations.
Remarque L'unité Digi Connect Sensor+ contient des batteries internes.
AVERTISSEMENT! L'unité Digi Connect Sensor+ est adaptée pour utilisation seulement
dans des endroits non dangereux ou des endroits dangereux UL/cUL de classe I, division
2, groupes B, C et D. Le remplacement de tout composant risquerait de compromettre la
convenance à la classe I, division 2.
AVERTISSEMENT - RISQUE D'EXPLOSION: LES BATTERIES DOIVENT ÊTRE REMPLACÉES
DANS UN ENDROIT EXEMPT DE CONCENTRATIONS INFLAMMABLES.
AVERTISSEMENT - RISQUE D'EXPLOSION: NE DÉCONNECTEZ PAS LORSQUE LE CIRCUIT
EST SOUS TENSION OU À MOINS QUE LA ZONE SOIT LIBRE DE TOUTE CONCENTRATION
INFLAMMABLE.
Digi Connect Sensor+ User Guide
Safety notices
121