Battery Care And Maintenance; Battery Sleep And Wake Modes; Battery Life - Digi Connect Sensor+ User Manual

Hardware
3. Place the magnet on one corner of the device. Be sure to match the hole in the magnet to the
hole in the corner.
4. Remove one of the screws from the accessory pack.
5. Using the screwdriver, screw the magnet onto the device.
6. Repeat this process to screw the remaining magnets onto the corners of Digi Connect Sensor+.
When you have completed this process, a magnet should be screwed onto each corner of the
device.

Battery care and maintenance

Note Before you open a Digi Connect Sensor+ be sure to review the

Battery sleep and wake modes

Digi Connect Sensor+ uses sleep and wake modes to manage power use. The device wakes only for
sensor readings and sending reports to Remote Manager. It is in sleep mode at all other times to
maintain low power consumption.

Battery life

The battery life will stay at 100% during the useful life of a battery. When the battery life is at 50%
there is enough battery life to power the Connect Sensor as expected for a month, which gives you to
time to replace the battery.
You should consider setting an alarm for when the battery life reaches 50% so that you can schedule a
change. See Configure battery life percentage
Digi Connect Sensor+ User Guide
CAUTION! The magnets are extremely powerful. Keep magnets separated. If
they touch each other they are difficult to separate. Use caution when handling
the magnets to avoid injury due to pinching.
alarms.
Battery care and maintenance
Battery safety information.
22