Step 6: Wire The I/O Sensors; Step 7: Add A Device To Digi Remote Manager - Digi Connect Sensor+ User Manual

Get started
NEXT STEP: After reviewing components, proceed to

Step 6: Wire the I/O sensors

You can wire the analog and digital input/output sensors or power using the I/O interface. For detailed
information, see the
Note All external or field wiring must be in accordance with NFPA 70 Article 501.10(B).
After wiring sensors, use the following sections in this guide to configure additional settings and
remotely manage Digi Connect Sensor+.
Configure pins and protocols
n
View device and sensor data streams
n
Configure Digi Connect Sensor+ device settings
n
NEXT STEP: After reviewing components, proceed to

Step 7: Add a device to Digi Remote Manager

To manage Digi Connect Sensor+ and get sensor data, you need to create a Remote Manager account
and add your Digi Connect Sensor+ device to your account.
To add a device to Remote Manager:
1. Sign in to your Remote Manager account:
If you need to create an account, go to
n
setup a free trial and purchases an extended license.
If you already have an account, go to Remote Manager at
n
sign in with your user name and password.
2. In the left-hand pane, click Devices. The Devices pane displays.
3. Make sure the Single Devices tab is selected. It is selected by default.
4. Click Add. The Add dialog displays in the right-hand pane.
a. In the Device ID, MAC Address, or IMEI field, enter one of these items, which are
b. In the Device Default Password field, enter the device's default password, which is
c. In the Device Name field, enter a descriptive name for the device.
5. Click Add Device to add the device.
6. Click OK to close the Add Devices dialog. The device appears in the Device Management list.
Note If the device does not display in the Device Management list, you can wake Digi Connect
Sensor+ to force a connection with Remote Manager and update the data. For instructions,
see Update the firmware using the CLI
Digi Connect Sensor+ User Guide
Digi Connect Sensor I/O Wiring
located on the device label. An entry in this field is required. For more detailed
information, see the Device IDs
on the device label.
Step 6: Wire the I/O
Guide.
Step 7: Add a device to Digi Remote
shop.digi.com/DigiRM
remotemanager.digi.com
section in the Digi Remote Manager User
or Update the firmware from Remote
Step 6: Wire the I/O sensors
sensors.
Manager.
to create an account,
and
Guide.
Manager.
15