Digi Connect Sensor+ User Manual page 31

Firmware updates
You may need to install device drivers or wait for your computer to automatically install them
when connecting Digi Connect Sensor+ to a computer using a USB cable. Digi recommends
drivers available at www.ftdichip.com/Drivers/VCP.htm.
4. Open a terminal program on a computer and connect to Digi Connect Sensor+ using the
following configuration:
Connection port: Connect to the COM port associated with the USB cable connected to
n
Digi Connect Sensor+
Baud rate or bits per second: 115200
n
Data: 8 bit
n
Parity: None
n
Stop: 1 bit
n
Flow control: None
n
5. Press the Wake button. The command prompt appears in the terminal program window.
6. In the terminal program:
a. Type fwupdate at the command prompt and select the YMODEM protocol to send
b. Press Enter. The device remains awake to load and install the firmware update.
7. Press the Wake button and type status at the command prompt to verify the firmware version.
Digi Connect Sensor+ User Guide
the firmware file to the device. Refer to your terminal program documentation for
how to use the YMODEM protocol.
After the device completes the change, it sends its updated status information to
Remote Manager.
Update the firmware using the CLI
31