Internal Temperature Cli Commands - Digi Connect Sensor+ User Manual

Internal temperature CLI commands

Use the following command with the set command when configuring the device with the CLI.
CAUTION! If Digi Connect Sensor+ sends reports less than 15 minutes apart, it may result in an internal temperature that is above the
ambient temperature.
CLI
Option commands Description
Internal ena Enables or disables the internal temperature sensor.
temperature
interface
Enables or disables alarm reports for the internal
Alarms aem
temperature. When enabled, sends an alarm report in
one of the following conditions:
High threshold alh Specifies the internal temperature in degrees Celsius
that generates a high alarm report when the high
alarm is enabled.
Low threshold all Specifies the internal temperature in degrees Celsius
that generates a low alarm report when the low
alarm is enabled.
High alarm
n
Low alarm
n
Value options
on
n
off
n
hi
n
lo
n
Enable multiple alarms using a comma
n
separated command without spaces
(such as set ain1 aem=hi,lo)
-100 to 100
-100 to 100
Default
off
Empty (all
disabled)
50.0
0