Setting Media Type - MUTOH DrafStation User Manual

3.2.4 Setting media type

Introduction:
When loading media in the Drafstation, you'll have to set the media type. The Media setup menu is displayed
after pushing the media hold lever from the backward position to the forward position.
Notes
•
The plotter starts the media initialisation without setting the media type when
Pressing the [Cancel] key.
o
No key operations are performed on the operation panel for 10 seconds.
o
Procedure:
Step 1 : Verify that the printer has been switched ON, and the media has been loaded.
Result: The display shifts to the media setup menu after loading media.
Step 2 : Press the [Setting value +] key or [Setting value-] key on the operation panel to select the correct
media type:
•
User1, User2, User3, User4
• MonoTrac
•
Col.Trac
• Plain
•
Coat
•
Film
•
Photo
Step 3 : Press the [Enter] key on the operation panel to confirm your choice.
Result: · The media type is determined.
• · The operation panel displays "Paper Initial", and media initialisation starts.
N°
1 Media hold lever
44
User's Guide DrafStation and Drafstation Pro
Name
Chapter 3: Basics
AP-75730, Rev. 2.1, 19/01/2009