Setup Menu Items; Testplot Menu - MUTOH DrafStation User Manual

6.2.3 Setup menu items

Setup item

TestPlot Menu

MediaSet Menu
Command Menu
PenSetup Menu
Layout Menu
Function Menu
Network Menu
Utility Menu
Consumption Menu
We will put the settings in three categories:
1. Settings that are needed to operate the machine, marked in BLACK
2. Settings are used only for compatibility with the old HPGL protocol, these are marked in
3. Settings that are used to operate the machine, but that are controlled / overruled by RIP software.
These will be marked in
These settings are in the machine only for troubleshooting, in case your RIP software is failing to
control them.
Notes
•
When the menu display item of the Utility menu is set to Normal, the following menus will NOT be
displayed.
ο Command Menu
ο PenSetup Menu
ο Function Menu
ο BiDir Port item of Network Menu
Notes
•
< > parts in each list are factory default settings (initial values).
6.2.3.1 TestPlot Menu
To perform various test prints.
Setup item
SetupPlot
NozzleCheck
AdjustPlot
PalettePlot
Maintenance
To perform a Test plot.
To make various settings on printing media.
To set various conditions of the plotter commands.
To make various settings on the pen used for printing.
To make various settings on the layout function.
To make various settings on the process of print data.
To make various settings on the network interface.
To make various settings on the advanced functions of the plotter.
To display the remaining ink quantity and life cycle status of the cutter.
BLUE
To print the Setup list.
Refer to: "SetupPlot"
To print the Nozzle check pattern.
Refer to: "NozzleCheck"
To perform a head alignment.
Refer to: "AdjustPlot"
To print the pen colour palette of the plotter.
Refer to:"PalettePlot"
Plots out a small maintenance record.
User's Guide DrafStation and Drafstation Pro
Description
Description
117
Chapter 6: Printer menu
RED
AP-75730, Rev. 2.1, 19/01/2009