Table of Contents
Advertisement
5.2.4 AdjustPlot
Used to align the print head.
Notes
•
This plotter has been adjusted for optimum print quality at the shipment from factory.
•
Align the print head when the print quality decreases after the installation environment or the media has
been changed.
Align the print head as described in the following procedure:
Step 1 :
Switch ON the plotter.
Step 2 :
Load more than A3 size print media.
Step 3 :
Perform a testplot for the alignment as described in: "Performing a testplot".
Step 4 :
Check the print sample and select the number which matches as the best straight line. It is N° 4
in the example.
Step 5 :
Press the [Setting value +] key or [Setting value-] key on the operation panel, and enter the
selected number.
Step 6 :
Press the [Enter] key on the operation panel to save the value.
User's Guide DrafStation and Drafstation Pro
Chapter 5: Preparations before printing
103
AP-75730, Rev. 2.1, 19/01/2009
Advertisement
Table of Contents
Troubleshooting
