MUTOH DrafStation User Manual page 132

(5) Media jams frequently occur.
Notes
•
If media other than dedicated one is used, correct media feeding cannot be assured.
N° Possible cause
1 Are you using dedicated media?
Is the media used in a place other than
2
the specified environment?
3 Using old media?
4 Using media with fold, wrinkle, etc?
5 Does the media curl or float?
(6) The media veers during printing.
N° Possible cause
1 Are you using dedicated media?
2 Is the loading position of the media correct?
3 Is the scroller set correctly?
(7) Roll media is not cut well.
N° Possible cause
1 Does the cutter blade cut well?
Is the roll media charged with static
2
electricity?
User's Guide DrafStation and Drafstation Pro
Remedy
Use the dedicated media.
Use the media in a dedicated environment.
Replace it with new media.
Use dedicated media.
If media that is not dedicated is used, set the
following items in the MediaSet Menu.
· Media
· Stiffness
Remedy
Use dedicated media.
Set the media correctly.
Set the scroller correctly.
Remedy
Replace the cutter blade.
Remove the charged static
electricity.
132
Chapter 7: Troubleshooting
Reference
"Media"
"Cautions on
handling media"
"Replacing roll
media"
"Loading sheet
media"
"Media"
"MediaSet Menu"
Reference
"Media"
"Loading roll media"
"Loading sheet media"
"Roll media installing"
Reference
"Replacing cutter
blade"
--
AP-75730, Rev. 2.1, 19/01/2009