Important Safety Instructions - MUTOH DrafStation User Manual

1.3 IMPORTANT SAFETY INSTRUCTIONS

• Do not install the plotter in the following places where there is a possibility that the plotter may be
damaged or might fall by chance.
On a shaky stand
o
Slanting location
o
Places where vibration of other machines etc. is transmitted
o
•
Do not stand on the plotter or do not place heavy things on top of it. The plotter may be damaged or
might fall by chance.
•
Cover the plotter with a blanket and cloth like table cloth and do not close the vent. If the vent is closed,
the plotter could accumulate heat inside and may cause fire.
•
Do not install the plotter in places where the humidity is high and in a dusty environment. It could lead to
electric shock and fire.
• Do not use a damaged power cable. It could lead to an electric shock and fire.
•
Do not take out or insert the power plug with wet hands. This could lead to an electric shock.
•
Do not connect earth cables in the following areas:
Gas pipes. Doing so may cause fire or an explosion.
o
Earth terminals for telephone lines or lightning rods. Doing so may cause a large flow of voltage if
o
lightning occurs.
Water pipes or faucets. If there is a plastic part in the pipe, the earthing will not work
o
correctly.
•
Do not insert or drop metal or objects which are easily combustible through the openings such as fresh
air inlet into the plotter. It could lead to an electric shock and fire.
•
When foreign substances or liquids such as water entered the plotter, do not use the plotter. It could lead
to an electric shock and fire. Immediately switch off the power switch, disconnect the power plug from
the electric socket, and contact your local MUTOH dealer.
•
While installing optional items, be sure to switch OFF the power of the plotter and pull out the power
plug. It could lead to an electric shock.
•
Wire the various codes (cable) as explained in the User's Guide. Wrong wiring could cause fire.
•
Be sure to use the power cable supplied with the plotter. If other power cables are used, it could cause
an electric shock or fire.
•
Make sure to use only the specified power supply (AC 100 V - 120 V or AC 220 V - 240 V). If a power
supply other than the specified voltage is used, it could cause an electric shock and fire.
•
Take power for the plotter directly from the power socket (AC 100 V - 120 V or AC 220 V - 240 V). Do
not use complex multiple plugs on the same socket. This could generate heat and might cause fire.
• Be sure to use a dedicated power socket with earth wire for the power supply, and connect it to the earth
wire. If the earth wire is not connected, an electric shock or fire may occur.
•
Pay attention to the following points, while handling the power cable.
o Do not do anything forcefully on the power cable.
o Do not keep heavy objects on the power cable.
o Do not bend, twist or pull the power cable by force.
o Do not route the power cable near heating appliances.
•
Pay attention to the following points while handling the power supply plug. Any mishandling of the power
cable could cause a fire.
Make sure that no foreign substances such as dust etc. are stuck to the power plug.
o
Make sure that the power plug is firmly inserted to the edge of the power socket.
o
•
Do not use the media hold lever during plotter initialization. If the carriage and the pressure rollers touch
each other, the plotter may break down.
User's Guide DrafStation and Drafstation Pro
11
Chapter 1 :Safety information
AP-75730, Rev. 2.1, 19/01/2009