Transporting The Plotter - MUTOH DrafStation User Manual

3.9.2 Transporting the plotter

Be sure to read and understand the safety warnings before handling the printer.
When transporting the plotter, it is necessary to pack the plotter as it was shipped, using the protective
materials and packing materials to protect the plotter from vibration and shocks.
Notes
•
When transporting the plotter, consult your MUTOH product dealer.
(1) Pre- transport procedure
Step 1 : Switch ON the plotter.
Step 2 : Verify that the plotter is in Normal mode.
Step 3 : Remove all ink cartridges.
Step 4 : Switch OFF the plotter.
•
Result: The operation panel displays "Transport Mode", and the plotter starts the ink rejecting
operation.
•
The ink rejecting operation takes about 2 minutes.
Step 5 : Verify that the power light faints when the ink rejection operations has been finished.
Step 6 : Remove the scroller.
Step 7 : Remove all cables.
Step 8 : Attach the protective material (metal plate) for attaching the head unit (1), and fix it with
thumbscrews (2).
Step 9 : Remove the plotter from the stand.
Refer to: Installation guide
Step 10 : Repack the plotter.
Post-transport procedure
Step 1 : Perform unpacking, assembling, and placing the plotter.
Refer to: Installation guide
Step 2 : Set the plotter in an available condition.
Refer to: "Transferring the plotter: (2) steps after transfer"
N°
1 Protective material (metal plate) for attaching the head unit
2 Thumbscrew
User's Guide DrafStation and Drafstation Pro
Name
61
Chapter 3: Basics
AP-75730, Rev. 2.1, 19/01/2009