Handling Curled Media - MUTOH Kona Application Manual

Chapter 6
Next to multiple kinds of media, the Kona is also able to load curled media.
However, to perform this action, there are some extra items you need to keep in mind.
Please follow the procedure below to load curled media properly.
Determine the type of media e.g. sheet media and install the correct configuration.
Step 1:
Guide the media under the pressure rollers at the front of the cutter.
Step 2:


Position the pressure rollers (1) so that every pressure roller faces a grit roll (2).
Step 3:
Each pressure roller has a tactile and audible click system which makes it easier to
position them correctly.
Refer to pressure roller positioning in the User's Guide
AP-75381 - Revision 1.3
Handling curled
media
Verify that the front edge of the media is loaded at least 7 cm past the cutting
head.
Make sure that the rear of the media is still covering the sensors when the cutter
measures the cutfile. We advise a rear safety margin of at least 30 cm.
1
2
z
Application Guide Kona / Kona apparel
6
95