MUTOH DrafStation User Manual page 40

Notes
•
Do not match the roll media's right edge with the loading mark using force; this could cause the media
to slant.
Step 7 : Wind back the roll media (1) with the scroller (2) while pressing down (see left image) the media
at the front side of the plotter. This will reduce bending and avoid slant of the media. See images
below.
Step 8 : Pull the media hold lever (1) forward as shown on the image below.
Notes
•
If the front edge of the roll media is not straight, cut it straight. For the cutting method, Refer to: "Cutting
media".
• If the length of the edge to be cut is set on the media setup menu, the roll media edge will be
automatically cut after the media initialization. For the setting method, Refer to: "MediaSet Menu"
Step 9 : Close the front cover (1).
Result: The operation panel displays the Media setup menu.
N°
1 Roll media
2 Scroller
N°
1 Media hold lever
40
User's Guide DrafStation and Drafstation Pro
Name
Name
Chapter 3: Basics
AP-75730, Rev. 2.1, 19/01/2009