MUTOH DrafStation User Manual page 55

Step 6 : Softly push the knob of the cutter holder, and rotate the cutter holder lever (2) to the illustrated
direction simultaneously. See image below.
Notes
•
Do not strongly press or suddenly release the cutter holder knob, to prevent the built-in spring from
springing out.
•
Do not push the cutter holder to the end. The cutter blade will damage the inside of the plotter.
Step 7 : Remove the cutter as shown on the image below.
Notes
•
The used cutter must be put in a vinyl bag or bag used for this kind of waste. Disposal of a cutter blade
has to be done in compliance with the regulations and instructions of the local authorities.
Step 8 : Insert the new cutter as shown in the image below.
N°
1 Cutter holder
2 Cutter holder lever
N°
1 Cutter
N°
1
55
User's Guide DrafStation and Drafstation Pro
Name
Name
Name
Cutter
Chapter 3: Basics
AP-75730, Rev. 2.1, 19/01/2009