Table of Contents
Advertisement
Step 4 :
Wipe off the dirt of the grid roller's unpainted (silver colour) area with damp and a tightly
squeezed soft cloth.
4.1.4 Head cleaning
Be sure to read and understand the safety warnings before handling the printer.
When to perform?
If prints become blurred or are incomplete.
How to perform?
To perform a head cleaning, follow the steps below.
Notes
•
Remove media while cleaning.
Step 1 :
Verify that the operation panel is in Normal mode.
Step 2 :
Verify that the media hold lever is positioned to the front side.
Step 3 :
Press the [Cleaning] key on the operation panel for at least 2 seconds. See below.
Result: The operation panel displays "Cleaning ** minutes".
Step 4 :
Start the head cleaning.
Notes
•
Pressing the [Cleaning] key again within one printing after the 1st head cleaning performs strong
cleaning. If you fail to remove blurs or incompleteness of printing in one head cleaning, perform strong
cleaning.
•
If you fail to remove blurs or incompleteness of printing with several head cleaning, refer to
"Troubleshooting", and perform adequate process.
N°
1
Grid roller
94
User's Guide DrafStation and Drafstation Pro
Chapter 4: Periodical maintenance
Name
AP-75730, Rev. 2.1, 19/01/2009
Advertisement
Table of Contents
Troubleshooting
