9.2 Notes on Maintenance Procedures
9.2.7
Grease Replenishment for T-Axis Gear
1. Remove a plug from the grease exhaust port.
2. Remove bolts from the grease inlet, then install the grease zerk A-MT6 x 1. The
grease zerk is provided at factory.
3. Inject grease into the gear grease inlet using a grease gun. (Refer to " Fig. 33 T-Axis
Gear Diagram ".)
NOTE
The exhaust port is used for air flow. Do not inject excessive grease into the gear grease
inlet.
4. Remove the grease zerk from the grease inlet and reinstall the bolts.
Apply Three Bond 1206C to screwed parts when installing the bolts.
5. Reinstall the plug to the exhaust port.
Apply Three Bond 1206C to screwed parts when installing the plug.
Fig. 33 T-Axis Gear Diagram
Grease type: Harmonic grease SK-1A
Amount of grease: 5cc
(10cc for 1st supply)
9-17
Exhaust port
Plug LP-M5
Grease inlet
Hexagon socket head cap screw M6
HW0481893