Assembly - JLG 1850SJ Service And Maintenance Manual

14. Remove Split Ring (36), Input Shaft (42), and Bearing (37)
from Axle (38).
38
37
36

Assembly

NOTE: Thoroughly clean and coat all parts with grease before
assembling.
1. Check parts are free of damage, burrs, or other defects.
2. Install Bearing (37) in Axle (38). Install Input Shaft (42) in
Axle and Bearing. Secure with Split Ring (36).
38
37
36
3121619
42
42
SECTION 3 - CHASSIS & TURNTABLE
3. Install Seal (46), O-Ring (47), Seal (48), and O-Ring (49) in
Axle (38). Starting with Brake Disk (43) alternate with
Iron Disk (44) until a total of eight Brake Disks and nine
Iron Discs are installed on Input Shaft (42 - not shown) in
Axle.
44
45
47
48
49
43
46
4. Install Brake Piston (50) in Axle (38). Install five Brake
Springs (51) Piston holes. Install O-Ring (49) and Seal
(48) in Axle. Install Spacer (52) against Piston and secure
with Split Ring (53).
51
49
48
52
53
38
38
50
3-17