Swash Plate And Journal Bearing - JLG 1850SJ Service And Maintenance Manual

RISK OF PERSONAL INJURY: COMPRESSING THE BLOCK SPRING REQUIRES
ABOUT 80 TO 90 LBF (350 TO 400 N) OF FORCE. USE A PRESS SUFFICIENT TO
MAINTAIN THIS FORCE WITH REASONABLE EFFORT. ENSURE SPRING IS
SECURE BEFORE ATTEMPTING TO INSTALL THE SPIRAL RETAINING RING.
RELEASE PRESSURE SLOWLY AFTER RETAINING RING IS INSTALLED.
3. Install inner block spring washer (4), block spring (5),
and outer washer (6) in cylinder block (6A). Using a
press, compress block spring enough to expose retain-
ing ring groove. Wind spiral retaining ring (7) in cylinder
block groove.
10
9
8
6A
4. Block Spring Washer
5. Block Spring
6. Outer Washer
6A. Cylinder Block
7. Spiral Retaining Ring
4. Turn block over and install retaining ring (8), hold-down
pins (9), and ball guide (10) to cylinder block.
5. Install pistons (11) to slipper retainer (12). Install piston/
retainer assembly in cylinder block. Ensure concave sur-
face of retainer seats on ball guide. If reusing pistons,
install them in original block bores. Lubricate pistons,
slippers, retainer, and ball guide before assembly. Set
cylinder kit aside on a clean surface until needed.
3121619
11
12
4
5
6
7
8. Retaining Ring
9. Holddown Pins
10. Ball Guide
11. Piston
12. Slipper Retainer
SECTION 3 - CHASSIS & TURNTABLE
6. Install journal bearings (13) in housing seats. Use assem-
bly grease to keep bearings seated during assembly.
Ensure locating nubs drop into seat cavities. If reusing
bearings, install in original location and orientation.
Lubricate journal bearings.
14
13
13
13. Journal Bearings
14. Swash Plate
Figure 3-28. Swash Plate and Journal Bearing
7. Install swashplate (14) in housing. Tilt swashplate and
guide servo lever ball into its socket in the servo piston
rod. Ensure swashplate seats into journal bearings and
moves freely. Lubricate running surface of swashplate.
3-33