Deutsch Connectors; Dt/Dtp Series Assembly; Dt/Dtp Series Disassembly - JLG 1850SJ Service And Maintenance Manual

Hide thumbs Also See for 1850SJ:

Table of Contents

7.5 DEUTSCH CONNECTORS

Figure 7-14. DT/DTP Contact Installation

1. Grasp crimped contact about 25mm behind the contact

2. Hold connector with rear grommet facing you.

3. Push contact straight into connector grommet until a

click is felt. A slight tug will confirm that it is properly

locked in place.

4. Once all contacts are in place, insert wedgelock with

arrow pointing toward exterior locking mechanism. The

wedgelock will snap into place. Rectangular wedges are

not oriented. Thy may go in either way.

NOTE: The receptacle is shown - use the same procedure for plug.

SECTION 7 - BASIC ELECTRICAL INFORMATION & ELECTRICAL SCHEMATICS

Figure 7-15. DT/DTP Contact Removal

1. Remove wedgelock using needlenose pliers or a hook

shaped wire to pull wedge straight out.

2. To remove the contacts, gently pull wire backwards,

while at the same time releasing the locking finger by

moving it away from the contact with a screwdriver.

3. Hold the rear seal in place, as removing the contact may

displace the seal.