JLG 1850SJ Service And Maintenance Manual page 452

SECTION 6 - JLG CONTROL SYSTEM
PARAMETER
SUBMENU
(DISPLAYED ON
(DISPLAYED ON ANALYZER 2
ANALYZER 1ST LINE)
JIB LEVEL: ACCEL X.Xs
DECEL X.Xs
MIN UP XX%
MAX UP XXX%
MIN DOWN XX%
MAX DOWN XXX%
GROUND M. LIFT UP XXX%
MODE:
M. lift DN XXX%
SWING XXX%
PLATFORM LVL XXX%
PLATFORM ROT XXX%
MAIN TELE XXX%
JIB (U/D) XXX%
JIB (L/R) XXX%
JIB TELE XXX%
JIB LEVEL XXX%
GEN SET/WELDER: Engine XXXX RPM
6-20
Table 6-4. Machine Personality Settings and Function Speeds
ND
LINE)
Displays/adjusts jib level acceleration
Displays/adjusts jib level deceleration
Displays/adjusts minimum jib level up speed.
Same as Creep speed
Displays/adjusts maximum jib level up speed
Displays/adjusts minimum jib level down
speed. Same as Creep speed
Displays/adjusts maximum jib level down
speed
Displays/adjusts fixed main lift up speed
Displays/adjusts main lift down speed
Displays/adjusts fixed swing speed
Displays/adjusts fixed basket level speed
Displays/adjusts fixed basket rotate speed
Displays/adjusts fixed main telescope speed
Displays/adjusts jib lift speed
Not displayed if JIB = 0
Displays/adjusts jib swing speed
Displayed if JIB = 2
Displays/adjusts jib tele speed
Displays/adjusts jib level speed
Control generator/welder RPM. Not displayed if
GEN SET/WELDER = 0
DESCRIPTION RANGE
0.1 to 5.0 sec
0.1 to 3.0 sec
0 to 65%
0 to 100%
0 to 65%
0 to 100%
0 to 100%
0 to 100%
0 to 100%
0 to 100%
0 to 100%
0 to 100%
0 to 100%
0 to 100%
0 to 100%
0 to 100%
1200-2800
DEFAULT TIME RANGE
VALUES (SEC)
1.5
0.5
60
100
60
100
60
60
60
75
75
60
80
80
80
100
1800 1800 for 60Hz ,1900 for 50Hz
3121619
1001172159-C