SECTION 6 - JLG CONTROL SYSTEM
6.9 JIB SENSOR CALIBRATIONS
To calibrate the jib sensors, the analyzer must be in access
level 1. All jib sensors can be calibrated at one time or each cal-
ibration can be performed on an individual basis.
1. Position the Platform/Ground select switch to the
Ground position.
2. Plug the analyzer into the connector inside the Ground
control box.
3. Pull out the Emergency Stop switch and start the
engine.
6-64
4. The analyzer screen should read:
5. Use the arrow button to reach OPERATOR ACCESS. Hit
Enter.
6. Enter the Access Code, 33271.
7. Use the right Arrow key to reach CALIBRATIONS. Hit
Enter.
3121619