JLG 1850SJ Service And Maintenance Manual page 443

Configuration Digit
GLOW PLUG:
5
STARTER LOCKOUT:
6
ENGINE SHUTDOWN:
7
FUEL CUTOUT:
8
CHASSIS TILT:
9*
Note: Any of the selections above will light the tilt lamp when a tilted condition occurs and will sound the platform alarm when the machine is also above elevation.
* Certain market selections will alter default setting.
3121619
Table 6-2. Machine Configuration Programming Information
Number
0 NO GLOW PLUGS: No glow plugs installed.
1 AIR INTAKE: Glow plugs installed in the air intake on the manifold.
2 IN-CYLINDER: Glow plugs installed in each cylinder.
0 DISABLED: Automatic pre-glow time determined by ambient air temperature; engine start
can be attempted at any time during pre-glow.
1 ENABLED: Automatic pre-glow time determined by ambient air temperature; engine start is NOT permit-
ted until pre-glow is finished.
0 DISABLED: No engine shutdown.
1 ENABLED: Shutdown engine when coolant temperature is greater than 110 deg. C or the oil
pressure is less than 8 PSI.
0 RESTART: Engine allowed to be restarted multiple times when very low fuel level is reached
1 ONE RESTART: Engine allowed to be restarted once for 2 minutes when very low fuel level is reached
2 ENGINE STOP: Engine not able to restart when very low fuel level is reached
1 5 DEGREES + DRV CUT: Reduces the maximum speed of all boom functions to creep when
tilted more than 5 degrees and above elevation; also cuts out drive.
2 4 DEGREES + DRV CUT: Reduces the maximum speed of all boom functions to creep when tilted more
than 4 degrees and above elevation; also cuts out drive.
3 3 DEGREES + DRV CUT: Reduces the maximum speed of all boom functions to creep when tilted more
than 3 degrees and above elevation; also cuts out drive.
4 4 DEGREES + CUT: Reduces the maximum speed of all boom functions to creep when tilted more than 4
degrees and above elevation; also disallows tower lift up, tower telescope out, drive, main telescope out
and main lift up.
5 3 DEGREES + CUT: Reduces the maximum speed of all boom functions to creep when tilted more than 3
degrees and above elevation; also disallows tower lift up, tower telescope out, drive, main telescope out
and main lift up.
6 5 DEGREES + CUT: Reduces the maximum speed of all boom functions to creep when tilted more than 5
degrees and above elevation; also disallows tower lift up, tower telescope out, drive, main telescope out
and main lift up.
SECTION 6 - JLG CONTROL SYSTEM
Description
Default
Number
2
0
1
0
1
6-11