Assembly Instructions For Metric Iso 6149 (Mpp) Port Assembly Stud Ends - JLG 600SC Service And Maintenance Manual

SECTION 5 - BASIC HYDRAULICS INFORMATION & SCHEMATICS
Assembly Instructions for Metric ISO 6149 (MPP)
Port Assembly Stud Ends
1. Inspect components to ensure that male and female
threads and surfaces are free of rust, splits, dirt, foreign
matter, or burrs.
2. If O-ring is not preinstalled, install proper size, taking
care not to damage it. See O-ring Installation (Replace-
ment) for instructions.
CARE TO BE TAKEN WHEN LUBRICATING O-RING. AVOID ADDING OIL TO THE
THREADED CONNECTION OF THE FITTING. THE LUBRICATION WOULD CAUSE
INCREASED CLAMPING FORCE AND CAUSE FITTING DAMAGE.
3. Pre-lubricate the O-ring with Hydraulic Oil.
4. For Non-Adjustable Fittings and Plugs, thread the fitting
by hand until contact.
5. For Adjustable fittings, refer to Adjustable Stud End
Assembly for proper assembly.
5-38
6. Torque the fitting or nut to value listed in Table 5-24,
Metric Pipe Parallel O-ring Boss (MPP) while using the
Double Wrench Method.
NOTE: The table headings identify the Metric port and the type on
the other side of the fitting. The torque will be applied to
the Metric port.
NOTE: Torque values provided in Table 5-24, Metric Pipe Parallel
O-ring Boss (MPP) are segregated based on the material
configuration of the connection.
'ALUMINUM/BRASS FITTINGS OR ALUMINUM/BRASS
MATING COMPONENTS' indicate either the following
material configurations:
a. STEEL fittings with ALUMINUM or BRASS mating
components.
b. ALUMINUM or BRASS fittings with STEEL mating
components.
c. ALUMINUM or BRASS fittings with ALUMINUM or
BRASS mating components.
7. Inspect to ensure the O-ring is not pinched and the
washer is seated flat on the counterbore of the port.
3121776