JLG 1850SJ Service And Maintenance Manual page 445

Configuration Digit
LOAD SYSTEM:
17*
* Only visible under certain market selections.
* Certain market selections will limit load system options or alter default setting.
FUNCTION CUTOUT:
18*
* Only visible under certain market selections.
* Certain market selections will limit function cutout options or alter default setting.
GROUND ALARM:
19*
* Certain market selections will alter default setting.
OSCILLATING AXLE:
20
Note: The default settings (bold) will vary depending on the model selection with selection #0 being the initial default setting.
DISPLAY UNITS:
21*
* Certain market selections will alter default setting.
3121619
Table 6-2. Machine Configuration Programming Information
Number
0
NO: No load sensor installed.
1
WARN ONLY: Functions in creep, overload lamp lit, platform alarm beeps (5 sec ON, 2 sec OFF).
CUTOUT PLATFORM: All functions cutout, overload lamp lit, platform alarm beeps (5 sec ON, 2 sec OFF).
2
CUTOUT ALL: All functions cutout, flash overload light (500mS on, 500mS off), platform alarm beeps (5
sec ON, 2 sec OFF).
3
SPECIAL 1: Functions in creep, overload lamp lit, disables main telescope out & main lift up, platform
alarm beeps (5 sec ON, 2 sec OFF).
4
0 NO: No drive cutout.
1 BOOM CUTOUT: Boom function cutout while driving above elevation.
2 DRIVE CUTOUT: Drive cutout above elevation.
3 DRIVE CUT E&T: Drive cutout above elevation and tilted.
0 NO: No ground alarm installed.
1 DRIVE: Travel alarm sounds when the drive function is active (Option).
2 DESCENT: Descent alarm sounds when lift down is active (Option).
3 MOTION: Motion alarm sounds when any function is active (Option).
0 NO: No oscillating axle system installed.
1 YES: Oscillating axle system installed.
0 METRIC: units selection. (Deg. C, KPA, Kg.)
1 IMPERIAL: units selection. (Deg. F, PSI, Lbs.)
SECTION 6 - JLG CONTROL SYSTEM
Description
Default
Number
0
0
0
1
1
6-13