SECTION 5 - BASIC HYDRAULIC INFORMATION & HYDRAULIC SCHEMATICS
3. Remove socket head capscrews. (03 Flange or Multiple
Pump Stages Only).
Using a 4 mm internal hex wrench, loosen and remove
the two small socket screws placed in the center of the
cover. Repeat the same operation for the corresponding
screws on the rear flange.
5-160
4. Remove front flange.
Place the pump on the table and slowly remove the
front flange.
Be careful not to damage the shaft seal when removing
the flange. Avoid contact of the shaft seal lips with key-
way edges (in tapered and parallel shafts) or splined
shaft teeth.
Inspect the front flange and seal area.
Clean with shop solvent, dry, and set aside.
5. Remove rear cover.
Remover rear cover. Clean with shop solvent, dry, and
set aside. Visually inspect rear cover and seal area.
3121619