Hd30/Hdp20 Series Assembly; Hd30/Hdp20 Series Disassembly - JLG 1850SJ Service And Maintenance Manual

SECTION 7 - BASIC ELECTRICAL INFORMATION & ELECTRICAL SCHEMATICS

HD30/HDP20 Series Assembly

A
Figure 7-16. HD/HDP Contact Installation
1. Grasp contact about 25mm behind the contact crimp
barrel.
2. Hold connector with rear grommet facing you.
3. Push contact straight into connector grommet until a
positive stop is felt. A slight tug will confirm that it is
properly locked in place.
Figure 7-17. HD/HDP Locking Contacts Into Position
NOTE: For unused wire cavities, insert sealing plugs for full envi-
ronmental sealing
7-12
B
C

HD30/HDP20 Series Disassembly

A
Figure 7-18. HD/HDP Contact Removal
1. With rear insert toward you, snap appropriate size
extractor tool over the wire of contact to be removed.
2. Slide tool along into the insert cavity until it engages
contact and resistance is felt.
3. Pull contact-wire assembly out of connector.
Figure 7-19. HD/HDP Unlocking Contacts
NOTE: Do Not twist or insert tool at an angle.
B
C
3121619