To Connect The Jlg Control System Analyzer; Using The Analyzer - JLG 1850SJ Service And Maintenance Manual

Hide thumbs Also See for 1850SJ:

Table of Contents

SECTION 6 - JLG CONTROL SYSTEM

To Connect the JLG Control System Analyzer

1. Connect the four pin end of the cable supplied with the

analyzer, to the motor controller module located in the

platform box or at the power module and connect the

remaining end of the cable to the analyzer.

NOTE: The cable has a four pin connector at each end of the cable;

the cable cannot be connected backwards.

2. Power up the Control System by turning the lower key to

the platform or ground position and pulling both emer-

gency stop buttons on.

With the machine power on and the analyzer connected prop-

erly, the analyzer will display the following:

At this point, using the RIGHT

keys, you can move between the top level menu items. To

select a displayed menu item, press ENTER

selected menu item, press Escape

to scroll using the right and left arrow keys to select a different

. To cancel a

; then you will be able