JLG 1850SJ Service And Maintenance Manual page 128

SECTION 3 - CHASSIS & TURNTABLE
Deutz Blink
SPN FMI
Code Code
793 693 411 11
795 693 411 3
796 693 411 4
825 253 523009 9
826 146 523470 2
827 146 523470 2
828 146 523470 12
829 146 523470 12
3-78
Table 3-10. Engine Fault Codes
Description
DFC is stored in EEPROM and status kept until
check is allowed
to be carried out again
DFC can be reset by service routine 216
The sensed raw voltage
Air_uRawPEGRDeltaP is above the maxi-
mum threshold.
The sensed raw voltage value
Air_uRawPEGRDeltaP is above the mini-
mum threshold.
The pressure relief valve (PRV) has reached
the number of allowed activations.
The pressure relief valve (PRV) has been
opened due to excessive pressure.
The pressure relief valve (PRV) has been
opened due to excessive pressure.
Rail pressure relief valve: is open.
Shutoff conditions.
Rail pressure relief valve is open.
Warning conditions.
Possible Cause
deviation between desired O2 concentration in
intake air manifold
and the real O2-concentration within intake air
manifold > limit
EGR Delta pressure Sensor defect
EGR Delta pressure Sensor defect
Rail pressure has exceeded the trigger thresh-
old of the pressure limiting valve.
Rail pressure has exceeded the trigger thresh-
old of the pressure limiting valve.
Rail pressure has exceeded the trigger thresh-
old of the pressure limiting valve.
Shut Off after PRV Open
Warning PRV open
Action
Threshold for error detection is an internal ECU
threshold.
EGR-Valve mechanically blocked open or closed
EGR-pipe blocked with metall plate instead
sealing downstream EGR-Valve
EGR-Valve actuator defect
EGR-cooler defect (check for coolant water)
Reed Valve defect
Intake throttle blocked in closed position =>
Check intake throttle
Exhaust pressure too high => Check Exhaust
pressure
Check Nox-sensor upstream SCR catalyst
dp venturi sensor defect
Check cabling, if charge EGR Delta pressure sen-
sor is not working, check sensor and
if necessary replace it, check connection cable
and if necessary repair or replace it.
Check cabling. If charge EGR Delta pressure sen-
sor is not working, check sensor and
if necessary replace it, check connection cable
and if necessary repair or replace it.
Replace pressure relief valve (PRV) and reset
fault with Serdia.
Threshold for error detection is an internal ECU
threshold.
Reset the fault and at reappearance check injec-
tion system.
Threshold for error detection is an internal ECU
threshold.
Reset the fault and at reappearance check injec-
tion system.
Threshold for error detection is an internal ECU
threshold.
Check PRV opening counter and if necessary
replace PRV,
check rail-pressure sensor for plausibility and if
necessary replace it,
check FCU and if necessary replace it.
Threshold for error detection is an internal ECU
threshold.
Check PRV opening counter and if necessary
replace PRV,
check rail-pressure sensor for plausibility and if
necessary replace it,
check FCU and if necessary replace it.
3121619