Hd30/Hdp20 Series Assembly; Hd30/Hdp20 Series Disassembly - JLG 1200SJP Service Maintenance Manual

Hide thumbs Also See for 1200SJP:

Table of Contents

SECTION 7 - BASIC ELECTRICAL INFORMATION, ELECTRICAL & HYDRAULIC SCHEMATICS

HD30/HDP20 Series Assembly

Figure 7-14. HD/HDP Contact Installation

1. Grasp contact about 25mm behind the contact crimp

2. Hold connector with rear grommet facing you.

3. Push contact straight into connector grommet until a

positive stop is felt. A slight tug will confirm that it is

properly locked in place.

Figure 7-15. HD/HDP Locking Contacts Into Position

NOTE: For unused wire cavities, insert sealing plugs for full envi-

ronmental sealing

Figure 7-16. HD/HDP Contact Removal

1. With rear insert toward you, snap appropriate size

extractor tool over the wire of contact to be removed.

2. Slide tool along into the insert cavity until it engages

contact and resistance is felt.

3. Pull contact-wire assembly out of connector.

Figure 7-17. HD/HDP Unlocking Contacts

NOTE: Do Not twist or insert tool at an angle.

– JLG Lift –

Table of Contents