Verify configuration settings
On the Verify Configuration screen, clicking Next shows the configuration settings that will be
uploaded to the Digi device.
Save settings
The Save Settings page is displayed while the configuration settings are uploaded to the Digi
device. Other messages and wizards may be displayed during this step; click OK on message
boxes and Next on wizard screens to continue the installation process.
Finish the wizard and select next action
When the configuration settings have been uploaded to the Digi device, a Finish screen is
displayed. There are several options for what to do next, including registering the Digi device,
opening other device interfaces such as the web interface or command line interface to further
configure it, or configuring another Digi device. Click Finish to close the wizard.
To further configure the Digi device
Once a Digi device is configured through the Digi Device Setup Wizard, or if the Digi Device
Setup Wizard fails to complete for any reason, as needed, use one of the other device interfaces to
view and change the configuration. For example, open the web interface, and change configuration
settings there, or access the command-line interface and enter commands to display and change
configuration settings. For more information on using these interfaces, see "Configuration through
the web interface" on page 58, and "Configuration through the command line" on page 131.
C o n f i g u r e D i g i d e v i c e s
5 7