Lubrication Activities; Lubricating The Current Collector - ABB IRBP Product Manual

5 Maintenance

5.6.1 Lubricating the current collector

5.6 Lubrication activities

5.6.1 Lubricating the current collector
Current collector
The function of the current collector is to transfer the weld current through the
rotary unit. This takes place through a spring-loaded contact bar against the shaft.
The contact bar needs to be lubricated approximately after 400 hours of operation.
This should be done using a special grease, P34 from Nies, article number:
0501869-001.
Required equipment
Equipment
Grease
Standard tools
Grease gun
Continues on next page
182
DANGER
Turn off all electrical power, hydraulic and pneumatic pressure supplies before
entering the workspace of the manipulator.
See also Safety on page
© Copyright 2010-2020 ABB. All rights reserved.
17.
Note
Grease type: P34 from Nies. Article number:
0501869002.
Standard tools IRBP on page 312
Product manual - IRBP /D2009
3HAC037731-001 Revision: T