Recalibrating The Axes - ABB IRBP Product Manual

8.5 Recalibrating the axes

General
This measure is necessary when the external axes lack calibration values or you
wish to recalibrate the axes.
You should be aware that the programmed positions can change depending on
whether the new calibrated position differs from the previous position. The chapter
describes the procedure for the positioner, not for the robot. (Specialist know-how,
which is not described here, and equipment are required to calibrate the robot's
axes.) Calibration of the external axes is performed in different ways depending
on the type of positioner in question.
Positioners of the types A, L and MTD
1
2
3
4
5
6
7
8
9
10
11
Product manual - IRBP /D2009
3HAC037731-001 Revision: T
Note
This procedure should not be used if calibration values already exist for the
axis in question.
Action
Move the positioner's axes (axis) to respective zero positions
(synchronization marking).
• Be precise when adjusting the position of the axis so
that it lies in the centre of the marking. The marking is
made up of a machined groove or a machined notch
on the gearbox respective faceplates.
Tap ABB, to open the service window.
Tap Calibration.
Tap on the mechanical unit to be calibrated. When the unit
concerned is not visible in the window, use the scroll bar ar-
rows, in the lower part of the window.
Tap Calibration Parameters.
Tap Fine Calibration.
The system awaits a response:
• Tap Yes to proceed.
Select one or more axes, to be recalibrated.
Tap Calibrate.
The system awaits a response:
• Tap Calibrate, to confirm recalibration.
Tap Close.
© Copyright 2010-2020 ABB. All rights reserved.
8 Calibration information
8.5 Recalibrating the axes
Note
273