Maintenance And Repair - ABB IRBP Product Manual

1 Safety

1.5.1 Maintenance and repair

1.5 Maintenance and repair
1.5.1 Maintenance and repair
General
Corrective maintenance must only be carried out by personnel trained on the robot.
Maintenance or repair must be done with all electrical, pneumatic, and hydraulic
power switched off, that is, no remaining hazards.
Hazards due to stored mechanical energy in the manipulator for the purpose of
counterbalancing axes must be considered before maintenance or repair.
Never use the robot as a ladder, which means, do not climb on the controller,
manipulator, including motors, or other parts. There are hazards of slipping and
falling. The robot might be damaged.
Make sure that there are no loose screws, turnings, or other unexpected parts
remaining after work on the robot has been performed.
When the work is completed, verify that the safety functions are working as
intended.
Gearbox lubricants (oil or grease)
When handling oil, grease, or other chemical substances the safety information of
the respective manufacturer must be observed.
Warning
Hot oil or grease
Allergic reaction
Possible pressure
build-up in gearbox
Continues on next page
32
Note
Take special care when handling hot lubricants.
Description
Changing and draining gearbox
oil or grease may require hand-
ling hot lubricant heated up to
90 °C.
When working with gearbox lub-
ricant there is a risk of an allergic
reaction.
When opening the oil or grease
plug, there may be pressure
present in the gearbox, causing
lubricant to spray from the
opening.
© Copyright 2010-2020 ABB. All rights reserved.
Elimination/Action
Make sure that protective gear
like goggles and gloves are al-
ways worn during this activity.
Make sure that protective gear
like goggles and gloves are al-
ways worn.
Open the plug carefully and keep
away from the opening. Do not
overfill the gearbox when filling.
Product manual - IRBP /D2009
3HAC037731-001 Revision: T