Calibrating The Multi-Arc System - ABB IRBP Product Manual

8 Calibration information

8.7.2 Calibrating the multi-arc system

8.7.2 Calibrating the multi-arc system
Required equipment
Equipment
Pointer
Centre punch and hammer
Tool calibration
Start to calibrate the welding tool TCP using BullsEye.
1
2
Continues on next page
276
Article number
-
-
Action
Change the mass in the tool data from the negat-
ive value to the correct value for your tool, see
figure.
Activate the tool.
© Copyright 2010-2020 ABB. All rights reserved.
Note
Make a pointer that screws into the
tip adapter.
The point of the pointer should be in
exactly the same position as the
defined TCP, e.g. 15 mm from the end
of the nozzle.
xx1800000747
Used for making a punch mark on the
turning disc and the bearing disc
spigot (if available).
Note
xx1400000898
xx1800000746
Product manual - IRBP /D2009
3HAC037731-001 Revision: T