Process Position - ABB IRBP Product Manual

8.9.4 Process position

General
A process position is the position the positioner or positioner side is in after station
interchange. Set the process position so that it is in a suitable position for the first
position in the work program. The value is saved in data type partadv in the
component procAngle, which the pertinent part refers to in the component advPart.
Procedures
1
2
3
4
5
Product manual - IRBP /D2009
3HAC037731-001 Revision: T
Action
To change process position, the ABBmenu must
be opened.
• Tap Production Manager.
Tap Setup.
Choose the station for which the process position
will be changed.
• Tap GO.
If a part is not activated for the selected station, one
must be activated for the station. See section "Parts
handling" section 5.1.2 on how to do this.
Specify the desired process position in degrees.
© Copyright 2010-2020 ABB. All rights reserved.
8 Calibration information
8.9.4 Process position
Note
297