Cleaning Activities; Cleaning The Irbp - ABB IRBP Product Manual

5 Maintenance

5.5.1 Cleaning the IRBP

5.5 Cleaning activities

5.5.1 Cleaning the IRBP
General
To secure high uptime it is important that the IRBP is cleaned regularly. The
frequency of cleaning depends on the environment in which the product works.
Different cleaning methods are allowed depending on the type of protection of the
IRBP.
Oil spills
Oil spills from gearboxes
Use the following procedure if any oil spills are detected that can be suspected to
originate from a gearbox.
Special cleaning considerations
This section specifies some special considerations when cleaning the robot.
Continues on next page
180
DANGER
Turn off all:
• electric power supply
• hydraulic pressure supply
• air pressure supply
to the robot, before entering the safeguarded space.
Note
Always verify the protection type of the robot before cleaning.
1 Inspect that the oil level in the suspected gearbox is according to the
recommendations, see
2 Write down the oil level.
3 Inspect the oil level again after, for example, 6 months.
4 If the oil level is decreased then replace the gearbox.
• Always use cleaning equipment as specified. Any other cleaning equipment
may shorten the life of the robot.
• Always check that all protective covers are fitted to the robot before cleaning.
• Do not use compressed air to clean the robot.
• Never use solvents that are not approved by ABB to clean the robot.
• Do not spray from a distance closer than 0.4 m.
• Do not remove any covers or other protective devices before cleaning the
robot.
© Copyright 2010-2020 ABB. All rights reserved.
Inspection activities on page 172.
Product manual - IRBP /D2009
3HAC037731-001 Revision: T